Log - Records the event information in the system log when the alarm is triggerdħ. Tour - Enables a tour when the alarm is triggeredīuzzer - Makes the recorder emit an audible beeping noise when the alarm is triggered Post-Record - Sets the amount of seconds that are recorded after the alarm event is done being triggered, if "Record Channel" is enabled
![intrusion 2 wiki intrusion 2 wiki](https://cdn.dribbble.com/users/40571/screenshots/3525793/wiki.png)
PTZ Activation - Sets the behavior of a PTZ camera connected to the same recorder when the alarm is triggered Record Channel - Sets which channels are recorded when the alarm is triggered Send Email - Sends an email, via the settings set in the Email section of the Network settings on the recorder, when the alarm is triggered Latch - Sets how long the alarm outputs will stay activated when the alarm is triggered Period - Sets the time and days of the week this alarm can be triggeredĪlarm Out - Sets alarm outputs that will be activate when this alarm is triggered Select the Gear icon under "Trigger" to configure what happens when the tripwire alarm is triggered: When you are done configuring the Tripwire rules, select "OK".Ħ. Select the drop-down menu next to "Direction" to choose if the IVS alarm is triggered in both directions ("Both") or just one direction ("A To B" or "B To A")ĥ. Give this rule a name by selecting the text box next to "Name" and typing in a name. When done drawing the line segments, right click to finish the line. Continue moving your mouse and left clicking to continue making multiple segments of the tripwire line. Left click anywhere else on the camera view to complete the segment of the line. Left click anywhere on the camera view to start the tripwire line. Select "Add" at the bottom to create a new IVS alarm rule.Ĭlick on the drop-down menu under "Type" for the new rule you created and change set it to "Tripwire".Ĥ. Then choose the channel number at the top. Select and highlight "IVS" (You may need to deselect any other options). Then select the camera channel at the top.
![intrusion 2 wiki intrusion 2 wiki](https://www.giantbomb.com/a/uploads/original/15/157771/2311617-a19.jpg)
From the Main Menu select "Event" in the "Setting" section IP Camera with IVS added to an NVR, with the Old SystemUI, or an HDCVI Camera that is connected to a HDCVI DVR, with the Old SystemUI, that has IVSġ.
#Intrusion 2 wiki how to
As a result of its flexibility, simplicity and low cost relative to its effectiveness, capping is one of the most prevalent remedial technologies for sediments.This article will cover how to configure an IVS Tripwire Alarm on a Dahua recorder with the Old SystemUI Depending upon the erosive forces to which the cap may be subjected, the surface layer may be composed of relatively coarse material to withstand those erosive forces.In addition to providing chemical isolation and containment, a cap can also be used to provide improvements for organisms by enhancing the habitat characteristics of the bottom substrate. Amendments to enhance contaminant isolation include permeability reduction agents to divert groundwater flow, sorbents to retard contaminant migration through the capping layer or provide greater accumulation capacity, or reagents to encourage degradation or transformation of the contaminants. The clean substrate may be an inert material such as sand, a natural sorbing material such as other sediments or clays, or be amended with an active/reactive material to enhance the isolation of the contaminants. Capping serves to contain contaminated sediment solids, isolate contaminants from benthic organisms and reduce contaminant transport to the sediment surface and overlying water. Capping is an in situ remedial technology for contaminated sediments that involves placement of a clean substrate on the sediment surface.